Plush Making Basics

Sewing Tiny Curved Plush Pieces: Ears, Paws and Tails

How to sew small curved plush pieces like ears, paws and tails: prep, short stitches, clipping curves, turning tiny parts, stuffing and attaching them neatly.

On this page
  1. Why small curves are hard
  2. Prep
  3. Sewing technique on a machine
  4. Hand sewing option
  5. Clipping and trimming
  6. Turning tiny parts
  7. Stuffing and attaching
  8. Troubleshooting

Why small curves are hard

Ears, paws, tails and other small parts have tight curves and very little room. The seam allowance is large compared with the piece, so any irregularity shows. Fabric can shift under the presser foot, and once the piece is turned, an uneven seam or a missing clip makes a bump or a pucker. A bit of preparation and a slow, steady pace go a long way.

Prep

  • Mark the seam line on the wrong side with a fine pen or chalk, so you can follow a curve accurately.
  • Cut accurately. Small errors are more noticeable on small pieces.
  • Use clips or a few pins inside the seam allowance. Clips are less likely to distort fluffy fabric.
  • Stabilize if needed. For thin or stretchy fabric, lightweight fusible interfacing can help it hold its shape. Test on a scrap first.
  • Check the seam allowance. Small parts often use a smaller allowance, and the choice affects how the curve turns. See seam allowance for plush patterns.

Sewing technique on a machine

  1. Use a short stitch length, so the curve is smooth rather than angular and the seam is stronger. Reduce speed.
  2. Start on a straight section, backstitch, then sew along the marked line.
  3. Keep the needle down when you stop to pivot. Raise the foot slightly and rotate the fabric a little at a time, instead of forcing the curve.
  4. For tight curves, take a stitch or two at a time and pivot often.
  5. Leave the straight, open edge unsewn so you can turn and stuff the piece.
  6. Backstitch at the end.

A machine with good low-speed control and a free arm makes this easier. See sewing machine features for making stuffed animals.

Hand sewing option

If a part is too small for the machine, sew it by hand with small backstitches along the marked line. Hand sewing gives you precise control over every stitch, and it’s common for tiny paws and tails. See hand sewing stuffed animals for stitch details.

Clipping and trimming

Before turning, trim the seam allowance and clip the curves:

  • Outward (convex) curves, like the top of an ear: cut small V-shaped notches out of the seam allowance, being careful not to cut the stitches.
  • Inward (concave) curves: make small straight snips toward, but not through, the stitching.
  • Points and corners: trim off the tip of the corner diagonally, leaving a few threads of fabric beyond the stitches.
  • Trim the seam allowance to a narrower width on small pieces, to reduce bulk. For fabrics that fray, be careful not to trim too close.

Turning tiny parts

Use a thin, blunt tool, such as a chopstick, a blunt knitting needle or hemostats, to push the piece right side out. Take care at the tip. Push from inside to avoid poking through the seam, and use the tool to smooth the curve from within. Hemostats also let you grip the tip and pull the piece through. If the piece is very small, a length of thread knotted at the tip can help pull it through.

Stuffing and attaching

  • Stuff lightly, or not at all. Flat ears can often be left unstuffed or only partly filled. Paws and tails need small tufts of fiberfill, and a thin tool helps. See how to stuff a plushie evenly.
  • Attach securely. Tuck the open end into the body seam, or sew the piece to the body by hand with small stitches that run through both layers. Check the placement before you sew.
  • Match the pair. Hold both ears or paws up together to check that they look the same.

Troubleshooting

  • Puckered curve: it needs more clipping, or the stitches were too tight.
  • Pointy ear tip that won’t turn: trim more fabric at the point, and turn it slowly.
  • Bumpy seam: the stitching line wasn’t smooth. Re-sew with a shorter stitch and a steadier pace.
  • Uneven pairs: cut both from one template and mark them in the same way.

For the full process, from pattern to finish, see our beginner’s guide to making plushies.

The complete guide to plush making basics

How to Make Plushies: A Complete Beginner's Guide
Read the guide

Keep exploring

Guides from other topics

All topics →