What an invisible decrease is
A decrease reduces the number of stitches in a round, which is how amigurumi tapers toward the top of a head or the end of a limb. An invisible decrease is a version of the single crochet decrease worked so that it looks like a regular stitch instead of a small bump or hole. In a stuffed toy, where stitches are tight and visible, it helps the fabric look smooth.
Standard decrease vs invisible decrease
The standard single crochet decrease (often written sc2tog) goes through both loops of two stitches. It works fine, but it tends to leave small gaps between stitches, and it can make a slight ridge. Stuffing may peek through those gaps, especially in light-colored fill with dark yarn.
The invisible decrease goes through only the front loop of each of the next two stitches. This pulls the stitches together in a way that blends with the surrounding fabric. It is often written as “inv dec” or “invdec” in patterns.
Check your pattern, because some designers expect one method and some leave the choice to you. If a pattern simply says “dec” or “sc2tog,” using an invisible decrease instead is usually acceptable and does not change the stitch count.
Step-by-step
This is for right-handed crocheters. Mirror the steps if you crochet left-handed.
- Insert into the first front loop. Insert your hook into the front loop only of the next stitch. Do not go through the back loop.
- Insert into the second front loop. Without yarning over, insert your hook into the front loop only of the following stitch. You now have two loops from the stitches plus the loop already on your hook, which makes three loops.
- Yarn over. Yarn over and pull through the two front loops. You now have two loops on the hook.
- Yarn over again. Yarn over and pull through both loops on the hook.
That is one invisible decrease. It turns two stitches into one. If your pattern says “6 inv dec” in a round, repeat these steps six times.
Some tutorials describe a slightly different order, such as pulling through all three loops at once. The result is similar, so use whichever method feels natural to you and gives a tidy result.
Closing the final round
When the pattern says to fasten off and close, the technique is usually different:
- Cut the yarn, leaving a tail of several inches.
- Thread the tail onto a tapestry needle.
- Run the needle through the front loop of each remaining stitch around the opening.
- Pull the tail to cinch the opening closed.
- Push the needle through the center of the toy, tie a knot if needed, and weave the end away.
Stuff firmly before cinching. You cannot add stuffing afterwards without opening the work. See how to stuff a plushie evenly.
Common problems
- A visible hole. Make sure you went through only the front loops, and pull the yarn snug.
- A lump on one side. Spread decreases evenly around the round rather than stacking them in one place. Most patterns space them, but the position can drift if you lose your marker.
- Lost count. The stitch count should drop after each decrease, so count at the end of the round.
- Tension too loose. A hook that is too big leaves gaps even with a good decrease. See choosing the right hook size for amigurumi.
When to use which
Use an invisible decrease on visible surfaces such as heads, bodies and limbs. A standard decrease is fine when the area will be hidden, for example under a hat, or when the pattern requires it for a particular texture. Practicing both on a small ball is a quick way to see the difference.
For more basics, see our starter guide to crochet plushies and the magic ring tutorial. Both techniques appear in most no-sew crochet stuffed animals.