Cloth Dolls

Embroidering a Cloth Doll Face: Stitches and Placement

How to embroider a cloth doll face: materials, feature placement, the best stitches for eyes, nose and mouth, and fixes for puckering and uneven faces.

On this page
  1. Embroider before or after stuffing?
  2. Materials
  3. Placement basics
  4. Stitches for each feature
  5. Step by step
  6. Avoid common problems
  7. Related guides

Embroider before or after stuffing?

There are two common approaches, and both are used by experienced makers:

  • On the flat piece, before sewing. The fabric is easy to hold in a hoop, and your stitches are neat. The downside is that stuffing can distort the face afterwards, so features may shift slightly.
  • On the stuffed head. You can see the final shape and place features with more accuracy. It is harder to hold the head, and you need to bury thread ends inside the stuffing.

If you are new to this, flat embroidery is usually easier. Some makers like to place the features with pins on the stuffed head, then use those positions to guide the flat version on the next doll.

Materials

  • Fabric. Tightly woven, low-stretch fabric such as quilting cotton, muslin or felt gives the cleanest result. Stretchy fabric can pucker or distort.
  • Stabiliser. A layer of fusible interfacing on the back of thin or stretchy fabric helps stop puckering. Water-soluble stabiliser is another option for dark or thin fabric.
  • Embroidery floss. It usually comes as six strands. Many makers use two to three strands for small features, and more for bolder ones, but test on scrap.
  • Needle. A sharp embroidery needle with an eye big enough for the floss.
  • Marking tools. A water-soluble or air-erasable pen, pencil, or pins.
  • Hoop. Optional but helpful on flat fabric.

Placement basics

Face placement changes the doll’s look a lot. Some general guidelines:

  • Draw a light vertical centre line and a horizontal line for the eyes.
  • Placing the eyes around the middle of the head or slightly lower gives a younger, sweeter look. Higher eyes give an older, more adult look.
  • The mouth often sits roughly halfway between the eye line and the chin, though many makers place it a little closer to the chin for a childlike face.
  • Space the eyes about one eye-width apart or slightly more. Wide-set eyes look cute, while close-set eyes look more serious.
  • Keep the nose small, or leave it out. A tiny stitch or two is often enough.

Use pins or a marker to test positions, step back and look from a distance, and adjust. Different faces suit different dolls, so there is no single right answer.

Stitches for each feature

Eyes.

  • French knots: wrap the thread once or twice around the needle, then insert it next to where it came out. They make neat round dots. Use more wraps for bigger eyes.
  • Satin stitch: parallel stitches that fill a small shape. Good for oval eyes.
  • Backstitch or outline stitch: for closed eyes, outlines and lashes.

Mouth.

  • Backstitch or stem stitch along a drawn curve. Keep stitches short so the curve looks smooth.
  • Straight stitches for a simple line smile.

Nose.

  • Two tiny straight stitches, a small satin-stitched shape or a French knot.

Eyebrows.

  • A few short backstitches or a single curved stitch. Keep them light, since heavy brows can make a doll look severe.

Cheeks.

Step by step

  1. Stabilise the fabric if needed, and put it in a hoop.
  2. Lightly mark the eye line, centre line, and features.
  3. Start with a small knot or a waste knot, then bring the needle up at your first point.
  4. Stitch the eyes first, then the mouth, then the nose and brows.
  5. Keep your tension even, since pulling too tight can cause puckering.
  6. Fasten off by weaving the tail under existing stitches on the back, or, for a stuffed head, tie a knot and pull it into the stuffing.
  7. Remove the marks according to the pen’s instructions. Test on scrap, since some inks can remain.

Avoid common problems

  • Puckering: use stabiliser, a hoop, and lighter tension.
  • Uneven eyes: mark with pins, stand back, and check before stitching.
  • Thread showing through light fabric: avoid long threads across the back, and anchor with small stitches instead.
  • Thread pulling loose after washing: use secure knots and fasten off well.
  • Face looks too complicated: simplify. Two dots and a curve are often the best option.

For safety, embroidered features are a better choice than buttons or plastic eyes for toys meant for babies or toddlers. See making a baby-safe stuffed animal.

For adding hair after the face is done, see sewing yarn hair on dolls. For the whole doll-making process, see cloth doll making for beginners, and for a gentler, minimal face style, see making a Waldorf doll. For embroidered eyes on crocheted toys, see how to embroider eyes on amigurumi.

The complete guide to cloth dolls

Cloth Doll Making for Beginners
Read the guide

Keep exploring

Guides from other topics

All topics →